Plastidip spray Satinizer finish (400ml)

Spray paint canister (400ml) by PLASTI DIP Satin effect (Fade Buster) (USA format).

Paint cans of Effects Plasti Dip, have the same characteristics as the basic colors Plasti Dip, and are designed to achieve different shades when sprayed on the basic colors of Plasti Dip.

In this case, allow us get a satin finish, by spraying it on the different Plasti Dip colors, which are always always in matt finish.
 

This paint is used to cover objects and protect them from inclement weather (water), UV rays, etc. Once dry it remains flexible and completely odorless.

It's waterproof.

PLASTI DIP paints, once dry, can be removed by pulling them, as if it were a thin adhesive film. We do not need to sand the piece or use any type of solvent for the unpainting.

The liquid rubber PLASTI DIP forms a protective layer, rubber, very useful for sealing, cushioning and framing. It is also used as an anti-slip product. Especially recommended for indoor and outdoor use as it withstands extreme temperatures, from -34ºC to 93ºC. It is also resistant to acids, alkalis, salts, oils, as well as to many chemical agents.

Does not contain silicone and once dry, it can be easily removed.

Especially adherent to metals, wood, plastics, glass, fabrics, wool, stone, glass or carbon fibers, etc. To increase its adhesion we can use the primer product specially designed for the liquid rubber Plasti Dip.

How to use:

The surface to be protected must be dry, clean, and free of substances that hinder its adherence. Before opening the bottle and applying the product, shake gently and open. We must let it rest a few minutes to avoid air bubbles.

We can apply the PLASTI DIP paint using a brush or brush, we can also spray it, and we can also work by immersing the piece inside the paint canister.

To spray it, we can use the Plasti Dip paint spray bottle, or the aliquot paint bottle using the PLASTI DIP solvent to dilute the paint.

To achieve a good finish when painting by spray, we have to paint based on giving thin layers (from 4 to 6 layers on average), leaving a minimum drying time between layers and layer, about 6-10 minutes.

In this case of spraying, we recommend the use of electric guns (or also called turbine guns).
Technical information of the PLASTI DIP painting:

- Stable at temperatures between -34ºC and 93ºC.
- Optimum application temperature, around 20ºC.
- Minimum drying time on contact. 5 min approx.
- Complete drying time: 1 hour, depending on the thickness and number of layers applied.
- The manufacturer recommends layers of 0.2mm thickness, which will require 150gr of product per m2.