Plasti Dip - Multi Purpose Rubber Coating

Liquid paint pot PLASTI DIP, canned 650ml (USA format), matte transparent color.
This paint is used to coat objects and protect them from inclement weather (water) of the UV rays, etc. Once dry remains flexible and completely odorless. It is waterproof.
PLASTI DIP paints, once dried, can be removed (remove) pulling them, as if it were a thin adhesive film. No need to sand the piece or use any solvents for paint stripping.
The liquid rubber PLASTI DIP form a very useful sealing cushion and frame protective layer rubber. It is also used as anti-slip product. Especially recommended for use indoors and outdoors as it supports extreme temperatures from -34 ° C to 93 ° C. It is also resistant to acids, alkalis, salts, oils, as well as many chemicals.
Does not contain silicone and once dry, it can be easily removed.
Especially adherent to metal, wood, plastics, glass, fabrics, wool, stone, glass fibers or carbon, etc. To increase your grip and eliminate the possibility of Plasti Dip paint off once dry, we can use the primer specifically designed for Plasti Dip liquid rubber.
How to use:
The surface to be protected must be dry, clean, and free of substances that hinder adhesion. Before opening the bottle and apply the product, shake gently and open. We must let it stand a few minutes to avoid air bubbles.
We can PLASTI DIP apply paint using a brush or brush, we can also pulverize, and we can also work by immersion dipping the piece into the pot of paint.
To spray, paint need dilute solvent by using the PLASTI DIP.
To get a good finish when we paint spray paint have to give based thin layers (4 to 6 layers of media), leaving a minimum drying time between coats, about 6-10 minutes.
In this case spraying, we recommend the use of tasers (also called turbine).
Technical information PLASTI DIP painting:
- Stable at temperatures between -34 and 93 ° C.
- Optimal application temperature, about 20 ° C.
- Minimum drying time contact. 5 min. approx.
- Complete drying time: 1 hour, depending on the thickness and number of layers applied.
- The manufacturer recommends layers of 0.2mm thick, which will require 150 g of product per m2.